Panel mount connector for RTD sensor

Limited available quantity. Please use P2CON-XS12-PNL (3-pin) or contact us for lead time.  

This connector is compatible with the one we used on our deluxe cable. The panel mount connector is useful for small temperature control projects if you want the temperature probe to be disconnected when not in use. However, it is hard to find nowadays because most manufacturers use circuit board mount connectors to reduce the assembly cost.

This three-pin connector can be mounted on the instrument panel.  It can be used for a three-wire RTD sensor. The connector contains spring locks to prevent disconnecting from accidental pulls on the sensor cable.

Left: Female Connector (For cable).
Right: Male Connector (For panel mounting)
Middle: Connector Pair.

Specifications: 

For the sensor connector of the WS-1500E series controllers, please click here.

To open the female connector, you need to unscrew the two small screws on the connector first. Here is the guide to check soldering points inside of the connector. Or check the video below for how to disassemble it.