This relay provides a simple and economical solution for switching any size 24/110/240VAC operated heater or motor. It is single pole, compact, one normal open (NO), 24VAC coil voltage, and rates up to 40A max of load (see specification table below). It is shipped with 4 insulated connectors as shown in the picture. The output connector is good for 14 ~ 16 AWG wire.
Four PIN connectors are included.
Wiring for R30A relay. NC terminal is not available on R30A-24-A
Compared with ice cub relay, this relay is more compact and expoxy sealed. All the connection are recessed. When connected with insulated connectors, it can be opreated out side of the controller box.
Compared with using an SSR, the advantage of this relay is compact size, no need for heat sink, no heat dissipation issue, real dry cut off and economical price. The disadvantage is limited life time and has to be switched at lower frequency than the SSR. If you don't need super high precision control (within 1 degree) and don't mind a small clicking sound, this relay is a better choice than the SSR.
Note: this relay cannot be triggered by VDC.
Specifications
| Type |
Power Relay |
| Nominal Coil Voltage |
24VAC |
| Contact Form |
SPST |
| Relay Type |
1 x NO |
| Life Expectancy |
Mechanical 1 x 107
Electrical 1 x 105at 30 A 120 VAC Res. N.O. |
| Contact Max Current |
40A at 277VAC, General Use
28A at 277VAC, General Use, 100k cycles
2HP at 250VAC
1HP at 125VAC
30A at 28VDC
20/60 (FLA/LRA) at 277VAC 30k cycles |
| Termination Style |
Quick Connect |
| Pin Count |
4 |
| Operating Temperature |
-55 to 85 °C (-67 to 185 °F) |
| Minimum Dropout Voltage |
>4.8 VAC |
| Pick-Up Voltage |
20.4 VAC |
| Mounting |
Flange Mount |
| Dimension |
50.2 x 27.5 x 27.8mm (1.97 x 1.08 x 1.09 inch) |
| Certification |
UL, CUR file E44211 |
| Manufacturer Part# |
AZ2280-1A-24AF |
This product was added to our catalog on Tuesday 25 August, 2015.
