This controller enclosure measures 10 x 8 x 8" (250 x 200 x 200 mm). The box is made of powder coated, 0.040" (1 mm) thick steel. The door comes with lock and key. The hinge of the door is removable. It can be installed on either the right or left side. This allows the user to put the pre-cut opening either on top or at the bottom without changing the door opening directions. Gasket and plugs are provided. The enclosure is designed to be mounted on a wall. You can directly mount it with screws or hang it on the wall with the optional hangers. For high power circuit, wall mount box is preferred because the heavy cords (14 AWG or thicker) are difficult to manage with a table top enclosure.
The box has a pre-cut hole on the top for external heatsink. If you are going to use SSR instead of contactor as the switching device, you can order the optional external mounted heat sink. The external mounted heat sink eliminates the venting requirement of the enclosure for internally mounted heat sink. It is more efficient and keeps the internal of the controller box free from the dust. Two different sizes of heat sink are offered, 4 A and 60A. The 40A heat sink is about 1 inch narrower and 1/4" shorter. Both heat sinks come with pre-drilled and tapped mounting holes for the box and SSR. 60A heat sink has mounting holes for two SSRs. Mounting screws and thermal conductive grease are included. There is no need to cut for installing the heat sink. Please select the heat sink size option when ordering.
The front panel of enclosure has the following knockouts:
The bottom of enclosure has the following knckouts:
- (1) Inner 18mm round hole: strain-relief power grip for 15A power cord (PCCON-15A).
- (1) Outer 28mm round hole: strain-relief power grip for 30A power cord (PCCON-30A).
- (1) 21mm round hole: 1/2 inch EMT Fitting.
The left of enclosure has the following knockouts:
- (2) 21mm round hole: 1/2 inch EMT Fitting.
The right of enclosure has the following knockouts:
- (2) 21mm round hole: 1/2 inch EMT Fitting.
- (1) 40x50mm rectagular hole: 2P Breaker Switch (SWM-DR, SWM-DR-C).
Optional DIN Rail set is offered. It includes one piece of DIN Rail, one pair of DIN Rail end caps and one set of mounting screws & nuts.
Please click here to download hanger installation guide
Note: Scratch & dent condition enclosure is available here.
Front View.
Left View
Right View
Bottom View
Top View, without Heatsink Installed
Optional Hanger
Assembled View (Front).
Click here to download enclosure drawing diagram.
This product was added to our catalog on Monday 30 September, 2019.
