Humidity Sensor

Product update: Cable option is out of stock. We only have sensor block in stock (no cable). 

This sensor can be used with Auber Humidity Controllers (TH102) to measure the relative humidity.

We offer two options for this humidity sensor. One is the sensor block only. Another is the sensor block with cable. For the sensor block only option, you need to install it to your current sensor cable. Please be noted, the white plug inside the sensor block (highlighted in red below) may not be compatible with the old version connector on your sensor cable, so you may need to use soldering tools to solder the cable directly to the sensor board inside. It is not a plug-n-play solution then. For sensor block with cable option, you can directly plug it into your controller port.

The disassembled humidity sensor is shown in the picture below.