Panel Cap for 1/16 DIN hole

This cap is for 1/16 DIN panel cutout (45x45 mm). It is for covering up the 1/16 DIN sized cutout on the controller panel that is being saved for future use.  Snap-in design can be used to directly mount on your cutout easily, without any glue or tapes. The cap has a smooth and flat surface with beveled edges.

Two cap options are available for different panel thicknesses. The maximum mounting thickness for option A (default) is 2.0 mm. The maximum mounting thickness for option B is 2.4 mm (3/32 inch). 

 

1. Latch design for easy installation/removal

2. Light weight, clean look
3. Panel thickness: less than 2.0 mm (option A). 
                               2 ~ 2.4 mm (option B). 

If you need a cap in different dimension, please contact us. 

 

Note: Refurbished CAP-D16 is limited in stock. Please check here.

 

 SYL PID controller with 1/16 DIN cap


 Flat with beveled edge (front)