Wall mount sensor for H series WSD controller

Replacement probe selection guide for electric smoker controller

Note: This probe is compatible with AW-1520H H series controllers and SYL-3615 controller. It is not compatible with C series controller like WSD-1204CPH, WSD-1503CPH. 

This sensor is designed to be mounted on the back wall of the smoker cabinet. Comparing with the free-hanging, the wall mount sensor makes the smoker looks neater. Once it is mounted, you don’t need to worry about the sensor location again. However, mounting this sensor means that you need to drill a 5/16” diameter hole on the back wall of the smoker (not a plug-n-play operation). In most situations, the readings of both types of sensors are identical. But when the cabinet is empty, the reading of the wall mount sensor might be 3 to 4˚F higher than the free hanging sensor located in the center. This is because the heater is located in the bottom back. When there is no food on the shelf, the hot air will take a short cut to the top along the back wall. A unique design of the sensor is the thermoplastic mounting base. It slows down the heat sink effect of the sheet metal wall which causes the sensor reading lower than actual temperature. The length and diameter of the sensor are also optimized for the accuracy and response speed.

The connector is molded 3.5 mm jack, providing great protection from water and moisture. The cable is protected by stainless steel braiding, which gives it the same mechanical strength as teflon cable. The inner floropolymer insulation is rated for 300°C.

This sensor fits the H series WS or WSD controllers, including WSD-1500H-W. It does not work for A, B, C, D and G series WS or WSD controllers (e.g., model WS-XXXXA, WS-XXXXAPH, WS-XXXXB, WS-XXXXC, WSD-XXXXCPH, WSD-1200GPH and WSD-1501GPH). It does not work for Auber SYL or SMD series controllers neither.
 

Specifications
 

Click here to download installation guide.